177 lines
4.7 KiB
C
177 lines
4.7 KiB
C
|
/*
|
||
|
* Driver for the NXP ISP1760 chip
|
||
|
*
|
||
|
* Copyright 2014 Laurent Pinchart
|
||
|
* Copyright 2007 Sebastian Siewior
|
||
|
*
|
||
|
* Contacts:
|
||
|
* Sebastian Siewior <bigeasy@linutronix.de>
|
||
|
* Laurent Pinchart <laurent.pinchart@ideasonboard.com>
|
||
|
*
|
||
|
* This program is free software; you can redistribute it and/or
|
||
|
* modify it under the terms of the GNU General Public License
|
||
|
* version 2 as published by the Free Software Foundation.
|
||
|
*/
|
||
|
|
||
|
#include <linux/delay.h>
|
||
|
#include <linux/gpio/consumer.h>
|
||
|
#include <linux/io.h>
|
||
|
#include <linux/kernel.h>
|
||
|
#include <linux/module.h>
|
||
|
#include <linux/slab.h>
|
||
|
#include <linux/usb.h>
|
||
|
|
||
|
#include "isp1760-core.h"
|
||
|
#include "isp1760-hcd.h"
|
||
|
#include "isp1760-regs.h"
|
||
|
#include "isp1760-udc.h"
|
||
|
|
||
|
static void isp1760_init_core(struct isp1760_device *isp)
|
||
|
{
|
||
|
u32 otgctrl;
|
||
|
u32 hwmode;
|
||
|
|
||
|
/* Low-level chip reset */
|
||
|
if (isp->rst_gpio) {
|
||
|
gpiod_set_value_cansleep(isp->rst_gpio, 1);
|
||
|
mdelay(50);
|
||
|
gpiod_set_value_cansleep(isp->rst_gpio, 0);
|
||
|
}
|
||
|
|
||
|
/*
|
||
|
* Reset the host controller, including the CPU interface
|
||
|
* configuration.
|
||
|
*/
|
||
|
isp1760_write32(isp->regs, HC_RESET_REG, SW_RESET_RESET_ALL);
|
||
|
msleep(100);
|
||
|
|
||
|
/* Setup HW Mode Control: This assumes a level active-low interrupt */
|
||
|
hwmode = HW_DATA_BUS_32BIT;
|
||
|
|
||
|
if (isp->devflags & ISP1760_FLAG_BUS_WIDTH_16)
|
||
|
hwmode &= ~HW_DATA_BUS_32BIT;
|
||
|
if (isp->devflags & ISP1760_FLAG_ANALOG_OC)
|
||
|
hwmode |= HW_ANA_DIGI_OC;
|
||
|
if (isp->devflags & ISP1760_FLAG_DACK_POL_HIGH)
|
||
|
hwmode |= HW_DACK_POL_HIGH;
|
||
|
if (isp->devflags & ISP1760_FLAG_DREQ_POL_HIGH)
|
||
|
hwmode |= HW_DREQ_POL_HIGH;
|
||
|
if (isp->devflags & ISP1760_FLAG_INTR_POL_HIGH)
|
||
|
hwmode |= HW_INTR_HIGH_ACT;
|
||
|
if (isp->devflags & ISP1760_FLAG_INTR_EDGE_TRIG)
|
||
|
hwmode |= HW_INTR_EDGE_TRIG;
|
||
|
|
||
|
/*
|
||
|
* The ISP1761 has a dedicated DC IRQ line but supports sharing the HC
|
||
|
* IRQ line for both the host and device controllers. Hardcode IRQ
|
||
|
* sharing for now and disable the DC interrupts globally to avoid
|
||
|
* spurious interrupts during HCD registration.
|
||
|
*/
|
||
|
if (isp->devflags & ISP1760_FLAG_ISP1761) {
|
||
|
isp1760_write32(isp->regs, DC_MODE, 0);
|
||
|
hwmode |= HW_COMN_IRQ;
|
||
|
}
|
||
|
|
||
|
/*
|
||
|
* We have to set this first in case we're in 16-bit mode.
|
||
|
* Write it twice to ensure correct upper bits if switching
|
||
|
* to 16-bit mode.
|
||
|
*/
|
||
|
isp1760_write32(isp->regs, HC_HW_MODE_CTRL, hwmode);
|
||
|
isp1760_write32(isp->regs, HC_HW_MODE_CTRL, hwmode);
|
||
|
|
||
|
/*
|
||
|
* PORT 1 Control register of the ISP1760 is the OTG control register
|
||
|
* on ISP1761.
|
||
|
*
|
||
|
* TODO: Really support OTG. For now we configure port 1 in device mode
|
||
|
* when OTG is requested.
|
||
|
*/
|
||
|
if ((isp->devflags & ISP1760_FLAG_ISP1761) &&
|
||
|
(isp->devflags & ISP1760_FLAG_OTG_EN))
|
||
|
otgctrl = ((HW_DM_PULLDOWN | HW_DP_PULLDOWN) << 16)
|
||
|
| HW_OTG_DISABLE;
|
||
|
else
|
||
|
otgctrl = (HW_SW_SEL_HC_DC << 16)
|
||
|
| (HW_VBUS_DRV | HW_SEL_CP_EXT);
|
||
|
|
||
|
isp1760_write32(isp->regs, HC_PORT1_CTRL, otgctrl);
|
||
|
|
||
|
dev_info(isp->dev, "bus width: %u, oc: %s\n",
|
||
|
isp->devflags & ISP1760_FLAG_BUS_WIDTH_16 ? 16 : 32,
|
||
|
isp->devflags & ISP1760_FLAG_ANALOG_OC ? "analog" : "digital");
|
||
|
}
|
||
|
|
||
|
void isp1760_set_pullup(struct isp1760_device *isp, bool enable)
|
||
|
{
|
||
|
isp1760_write32(isp->regs, HW_OTG_CTRL_SET,
|
||
|
enable ? HW_DP_PULLUP : HW_DP_PULLUP << 16);
|
||
|
}
|
||
|
|
||
|
int isp1760_register(struct resource *mem, int irq, unsigned long irqflags,
|
||
|
struct device *dev, unsigned int devflags)
|
||
|
{
|
||
|
struct isp1760_device *isp;
|
||
|
bool udc_disabled = !(devflags & ISP1760_FLAG_ISP1761);
|
||
|
int ret;
|
||
|
|
||
|
/*
|
||
|
* If neither the HCD not the UDC is enabled return an error, as no
|
||
|
* device would be registered.
|
||
|
*/
|
||
|
if ((!IS_ENABLED(CONFIG_USB_ISP1760_HCD) || usb_disabled()) &&
|
||
|
(!IS_ENABLED(CONFIG_USB_ISP1761_UDC) || udc_disabled))
|
||
|
return -ENODEV;
|
||
|
|
||
|
/* prevent usb-core allocating DMA pages */
|
||
|
dev->dma_mask = NULL;
|
||
|
|
||
|
isp = devm_kzalloc(dev, sizeof(*isp), GFP_KERNEL);
|
||
|
if (!isp)
|
||
|
return -ENOMEM;
|
||
|
|
||
|
isp->dev = dev;
|
||
|
isp->devflags = devflags;
|
||
|
|
||
|
isp->rst_gpio = devm_gpiod_get_optional(dev, NULL, GPIOD_OUT_HIGH);
|
||
|
if (IS_ERR(isp->rst_gpio))
|
||
|
return PTR_ERR(isp->rst_gpio);
|
||
|
|
||
|
isp->regs = devm_ioremap_resource(dev, mem);
|
||
|
if (IS_ERR(isp->regs))
|
||
|
return PTR_ERR(isp->regs);
|
||
|
|
||
|
isp1760_init_core(isp);
|
||
|
|
||
|
if (IS_ENABLED(CONFIG_USB_ISP1760_HCD) && !usb_disabled()) {
|
||
|
ret = isp1760_hcd_register(&isp->hcd, isp->regs, mem, irq,
|
||
|
irqflags | IRQF_SHARED, dev);
|
||
|
if (ret < 0)
|
||
|
return ret;
|
||
|
}
|
||
|
|
||
|
if (IS_ENABLED(CONFIG_USB_ISP1761_UDC) && !udc_disabled) {
|
||
|
ret = isp1760_udc_register(isp, irq, irqflags);
|
||
|
if (ret < 0) {
|
||
|
isp1760_hcd_unregister(&isp->hcd);
|
||
|
return ret;
|
||
|
}
|
||
|
}
|
||
|
|
||
|
dev_set_drvdata(dev, isp);
|
||
|
|
||
|
return 0;
|
||
|
}
|
||
|
|
||
|
void isp1760_unregister(struct device *dev)
|
||
|
{
|
||
|
struct isp1760_device *isp = dev_get_drvdata(dev);
|
||
|
|
||
|
isp1760_udc_unregister(isp);
|
||
|
isp1760_hcd_unregister(&isp->hcd);
|
||
|
}
|
||
|
|
||
|
MODULE_DESCRIPTION("Driver for the ISP1760 USB-controller from NXP");
|
||
|
MODULE_AUTHOR("Sebastian Siewior <bigeasy@linuxtronix.de>");
|
||
|
MODULE_LICENSE("GPL v2");
|