tegrakernel/kernel/kernel-4.9/rt-patches/0058-clocksource-TCLIB-Allow-higher-clock-rates-for-clock.patch

From 8d1f0b94fd1f928439691c994f16de2cada21d07 Mon Sep 17 00:00:00 2001
From: Benedikt Spranger <b.spranger@linutronix.de>
Date: Mon, 8 Mar 2010 18:57:04 +0100
Subject: [PATCH 058/365] clocksource: TCLIB: Allow higher clock rates for
 clock events
MIME-Version: 1.0
Content-Type: text/plain; charset=UTF-8
Content-Transfer-Encoding: 8bit

As default the TCLIB uses the 32KiHz base clock rate for clock events.
Add a compile time selection to allow higher clock resulution.

(fixed up by Sami Pietikäinen <Sami.Pietikainen@wapice.com>)

Signed-off-by: Benedikt Spranger <b.spranger@linutronix.de>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
---
 drivers/clocksource/tcb_clksrc.c | 36 +++++++++++++++++++-------------
 drivers/misc/Kconfig             | 12 +++++++++--
 2 files changed, 31 insertions(+), 17 deletions(-)

diff --git a/drivers/clocksource/tcb_clksrc.c b/drivers/clocksource/tcb_clksrc.c
index ed1ae4445e8d..5b6f57f500b8 100644
--- a/drivers/clocksource/tcb_clksrc.c
+++ b/drivers/clocksource/tcb_clksrc.c
@@ -23,8 +23,7 @@
  *     this 32 bit free-running counter. the second channel is not used.
  *
  *   - The third channel may be used to provide a 16-bit clockevent
- *     source, used in either periodic or oneshot mode.  This runs
- *     at 32 KiHZ, and can handle delays of up to two seconds.
+ *     source, used in either periodic or oneshot mode.
  *
  * A boot clocksource and clockevent source are also currently needed,
  * unless the relevant platforms (ARM/AT91, AVR32/AT32) are changed so
@@ -75,6 +74,7 @@ struct tc_clkevt_device {
 	struct clock_event_device	clkevt;
 	struct clk			*clk;
 	bool				clk_enabled;
+	u32				freq;
 	void __iomem			*regs;
 };
 
@@ -83,13 +83,6 @@ static struct tc_clkevt_device *to_tc_clkevt(struct clock_event_device *clkevt)
 	return container_of(clkevt, struct tc_clkevt_device, clkevt);
 }
 
-/* For now, we always use the 32K clock ... this optimizes for NO_HZ,
- * because using one of the divided clocks would usually mean the
- * tick rate can never be less than several dozen Hz (vs 0.5 Hz).
- *
- * A divided clock could be good for high resolution timers, since
- * 30.5 usec resolution can seem "low".
- */
 static u32 timer_clock;
 
 static void tc_clk_disable(struct clock_event_device *d)
@@ -139,7 +132,7 @@ static int tc_set_oneshot(struct clock_event_device *d)
 
 	tc_clk_enable(d);
 
-	/* slow clock, count up to RC, then irq and stop */
+	/* count up to RC, then irq and stop */
 	__raw_writel(timer_clock | ATMEL_TC_CPCSTOP | ATMEL_TC_WAVE |
 		     ATMEL_TC_WAVESEL_UP_AUTO, regs + ATMEL_TC_REG(2, CMR));
 	__raw_writel(ATMEL_TC_CPCS, regs + ATMEL_TC_REG(2, IER));
@@ -161,10 +154,10 @@ static int tc_set_periodic(struct clock_event_device *d)
 	 */
 	tc_clk_enable(d);
 
-	/* slow clock, count up to RC, then irq and restart */
+	/* count up to RC, then irq and restart */
 	__raw_writel(timer_clock | ATMEL_TC_WAVE | ATMEL_TC_WAVESEL_UP_AUTO,
 		     regs + ATMEL_TC_REG(2, CMR));
-	__raw_writel((32768 + HZ / 2) / HZ, tcaddr + ATMEL_TC_REG(2, RC));
+	__raw_writel((tcd->freq + HZ / 2) / HZ, tcaddr + ATMEL_TC_REG(2, RC));
 
 	/* Enable clock and interrupts on RC compare */
 	__raw_writel(ATMEL_TC_CPCS, regs + ATMEL_TC_REG(2, IER));
@@ -191,7 +184,11 @@ static struct tc_clkevt_device clkevt = {
 		.features		= CLOCK_EVT_FEAT_PERIODIC |
 					  CLOCK_EVT_FEAT_ONESHOT,
 		/* Should be lower than at91rm9200's system timer */
+#ifdef CONFIG_ATMEL_TCB_CLKSRC_USE_SLOW_CLOCK
 		.rating			= 125,
+#else
+		.rating			= 200,
+#endif
 		.set_next_event		= tc_next_event,
 		.set_state_shutdown	= tc_shutdown_clk_off,
 		.set_state_periodic	= tc_set_periodic,
@@ -213,8 +210,9 @@ static irqreturn_t ch2_irq(int irq, void *handle)
 	return IRQ_NONE;
 }
 
-static int __init setup_clkevents(struct atmel_tc *tc, int clk32k_divisor_idx)
+static int __init setup_clkevents(struct atmel_tc *tc, int divisor_idx)
 {
+	unsigned divisor = atmel_tc_divisors[divisor_idx];
 	int ret;
 	struct clk *t2_clk = tc->clk[2];
 	int irq = tc->irq[2];
@@ -235,7 +233,11 @@ static int __init setup_clkevents(struct atmel_tc *tc, int clk32k_divisor_idx)
 	clkevt.regs = tc->regs;
 	clkevt.clk = t2_clk;
 
-	timer_clock = clk32k_divisor_idx;
+	timer_clock = divisor_idx;
+	if (!divisor)
+		clkevt.freq = 32768;
+	else
+		clkevt.freq = clk_get_rate(t2_clk) / divisor;
 
 	clkevt.clkevt.cpumask = cpumask_of(0);
 
@@ -246,7 +248,7 @@ static int __init setup_clkevents(struct atmel_tc *tc, int clk32k_divisor_idx)
 		return ret;
 	}
 
-	clockevents_config_and_register(&clkevt.clkevt, 32768, 1, 0xffff);
+	clockevents_config_and_register(&clkevt.clkevt, clkevt.freq, 1, 0xffff);
 
 	return ret;
 }
@@ -383,7 +385,11 @@ static int __init tcb_clksrc_init(void)
 		goto err_disable_t1;
 
 	/* channel 2:  periodic and oneshot timer support */
+#ifdef CONFIG_ATMEL_TCB_CLKSRC_USE_SLOW_CLOCK
 	ret = setup_clkevents(tc, clk32k_divisor_idx);
+#else
+	ret = setup_clkevents(tc, best_divisor_idx);
+#endif
 	if (ret)
 		goto err_unregister_clksrc;
 
diff --git a/drivers/misc/Kconfig b/drivers/misc/Kconfig
index e403ad6e89a6..8236b8cf56ec 100644
--- a/drivers/misc/Kconfig
+++ b/drivers/misc/Kconfig
@@ -69,8 +69,7 @@ config ATMEL_TCB_CLKSRC
 	  are combined to make a single 32-bit timer.
 
 	  When GENERIC_CLOCKEVENTS is defined, the third timer channel
-	  may be used as a clock event device supporting oneshot mode
-	  (delays of up to two seconds) based on the 32 KiHz clock.
+	  may be used as a clock event device supporting oneshot mode.
 
 config ATMEL_TCB_CLKSRC_BLOCK
 	int
@@ -84,6 +83,15 @@ config ATMEL_TCB_CLKSRC_BLOCK
 	  TC can be used for other purposes, such as PWM generation and
 	  interval timing.
 
+config ATMEL_TCB_CLKSRC_USE_SLOW_CLOCK
+	bool "TC Block use 32 KiHz clock"
+	depends on ATMEL_TCB_CLKSRC
+	default y
+	help
+	  Select this to use 32 KiHz base clock rate as TC block clock
+	  source for clock events.
+
+
 config DUMMY_IRQ
 	tristate "Dummy IRQ handler"
 	default n
-- 
2.28.0