58 lines
2.5 KiB
Plaintext
58 lines
2.5 KiB
Plaintext
* LTR 558/659 ALS/proximity sensor
|
|
|
|
nvs_ drivers use the NVidia Sensor (NVS) framework.
|
|
See the nvs.txt documentation for NVS DT capabilities.
|
|
The nvs_ltr659 ALS/proximity sensor driver supports the LTR558 and LTR659
|
|
devices.
|
|
If the part is known and is populated, then it can be specified in the DT:
|
|
Example: ltr659@23.
|
|
By specifying a device this way, the driver will assume this specific device
|
|
is populated during system boot and will not verify its existence. If, however,
|
|
the device is unknown or may not be populated, then the label, ltrX5X,
|
|
(e.g. ltrX5X@23), must be used. This tells the driver to find which device is
|
|
used. If the device is not found, the driver will unload itself. This also
|
|
requires that regulators be setup correctly for the probe function.
|
|
|
|
Required properties:
|
|
- compatible: Device or generic name.
|
|
Supported device names:
|
|
- liteon,ltrX5X
|
|
- liteon,ltr558als
|
|
- liteon,ltr659ps
|
|
Note: If the part is known and is populated, then it can be specified:
|
|
Example: compatible = "liteon,ltr659ps";
|
|
When specifying a device this way, the driver will assume this specific
|
|
device is populated during system boot and will not verify its
|
|
existence. If, however, the device is unknown or may not be populated,
|
|
then the label, ltrX5X, (Example: compatible = "liteon,ltrX5X";),
|
|
must be used. This tells the driver to find which device is used. If
|
|
the device is not found, the driver will unload itself. This requires
|
|
regulators to be setup correctly for the probe function.
|
|
- reg: i2c address of the device. It is 0x23.
|
|
|
|
Optional properties:
|
|
- status: set to "ok" or "okay" for normal operation. Set to anything else
|
|
to unload the driver without ever communicating with the device.
|
|
Note: The "anything else" above is typically "disabled".
|
|
Since the driver will unload without communicating with the device, the
|
|
device will be left in its POR state.
|
|
- light_disable: Setting this property to <1> will disable the light sensor.
|
|
- proximity_disable: Setting this property to <1> will disable the proximity
|
|
sensor.
|
|
Note: If the device supports both light and proximity, then to disable the
|
|
entire device so that the driver unloads, all sensors must be disabled:
|
|
light_disable = <1>;
|
|
proximity_disable = <1>;
|
|
- vdd-supply: regulator supply for chip
|
|
- vled-supply: regulator supply for led anode.
|
|
Note: These are required if the driver is to control the regulators.
|
|
|
|
Example:
|
|
|
|
ltr659@23 {
|
|
compatible = "liteon,ltr659";
|
|
reg = <0x23>;
|
|
vdd-supply = <&palmas_smps9>;
|
|
vled-supply = <&palmas_smps8>;
|
|
};
|