232 lines
7.9 KiB
Plaintext
232 lines
7.9 KiB
Plaintext
* Texas Instruments Keystone Navigator Queue Management SubSystem driver
|
||
|
||
The QMSS (Queue Manager Sub System) found on Keystone SOCs is one of
|
||
the main hardware sub system which forms the backbone of the Keystone
|
||
multi-core Navigator. QMSS consist of queue managers, packed-data structure
|
||
processors(PDSP), linking RAM, descriptor pools and infrastructure
|
||
Packet DMA.
|
||
The Queue Manager is a hardware module that is responsible for accelerating
|
||
management of the packet queues. Packets are queued/de-queued by writing or
|
||
reading descriptor address to a particular memory mapped location. The PDSPs
|
||
perform QMSS related functions like accumulation, QoS, or event management.
|
||
Linking RAM registers are used to link the descriptors which are stored in
|
||
descriptor RAM. Descriptor RAM is configurable as internal or external memory.
|
||
The QMSS driver manages the PDSP setups, linking RAM regions,
|
||
queue pool management (allocation, push, pop and notify) and descriptor
|
||
pool management.
|
||
|
||
|
||
Required properties:
|
||
- compatible : Must be "ti,keystone-navigator-qmss";
|
||
- clocks : phandle to the reference clock for this device.
|
||
- queue-range : <start number> total range of queue numbers for the device.
|
||
- linkram0 : <address size> for internal link ram, where size is the total
|
||
link ram entries.
|
||
- linkram1 : <address size> for external link ram, where size is the total
|
||
external link ram entries. If the address is specified as "0"
|
||
driver will allocate memory.
|
||
- qmgrs : child node describing the individual queue managers on the
|
||
SoC. On keystone 1 devices there should be only one node.
|
||
On keystone 2 devices there can be more than 1 node.
|
||
-- managed-queues : the actual queues managed by each queue manager
|
||
instance, specified as <"base queue #" "# of queues">.
|
||
-- reg : Address and size of the register set for the device.
|
||
Register regions should be specified in the following
|
||
order
|
||
- Queue Peek region.
|
||
- Queue status RAM.
|
||
- Queue configuration region.
|
||
- Descriptor memory setup region.
|
||
- Queue Management/Queue Proxy region for queue Push.
|
||
- Queue Management/Queue Proxy region for queue Pop.
|
||
- queue-pools : child node classifying the queue ranges into pools.
|
||
Queue ranges are grouped into 3 type of pools:
|
||
- qpend : pool of qpend(interruptible) queues
|
||
- general-purpose : pool of general queues, primarily used
|
||
as free descriptor queues or the
|
||
transmit DMA queues.
|
||
- accumulator : pool of queues on PDSP accumulator channel
|
||
Each range can have the following properties:
|
||
-- qrange : number of queues to use per queue range, specified as
|
||
<"base queue #" "# of queues">.
|
||
-- interrupts : Optional property to specify the interrupt mapping
|
||
for interruptible queues. The driver additionally sets
|
||
the interrupt affinity hint based on the cpu mask.
|
||
-- qalloc-by-id : Optional property to specify that the queues in this
|
||
range can only be allocated by queue id.
|
||
-- accumulator : Accumulator channel specification. Any of the PDSPs in
|
||
QMSS can be loaded with the accumulator firmware. The
|
||
accumulator firmware’s job is to poll a select number of
|
||
queues looking for descriptors that have been pushed
|
||
into them. Descriptors are popped from the queue and
|
||
placed in a buffer provided by the host. When the list
|
||
becomes full or a programmed time period expires, the
|
||
accumulator triggers an interrupt to the host to read
|
||
the buffer for descriptor information. This firmware
|
||
comes in 16, 32, and 48 channel builds. Each of these
|
||
channels can be configured to monitor 32 contiguous
|
||
queues. Accumulator channel property is specified as:
|
||
<pdsp-id, channel, entries, pacing mode, latency>
|
||
pdsp-id : QMSS PDSP running accumulator firmware
|
||
on which the channel has to be
|
||
configured
|
||
channel : Accumulator channel number
|
||
entries : Size of the accumulator descriptor list
|
||
pacing mode : Interrupt pacing mode
|
||
0 : None, i.e interrupt on list full only
|
||
1 : Time delay since last interrupt
|
||
2 : Time delay since first new packet
|
||
3 : Time delay since last new packet
|
||
latency : time to delay the interrupt, specified
|
||
in microseconds.
|
||
-- multi-queue : Optional property to specify that the channel has to
|
||
monitor up to 32 queues starting at the base queue #.
|
||
- descriptor-regions : child node describing the memory regions for keystone
|
||
navigator packet DMA descriptors. The memory for
|
||
descriptors will be allocated by the driver.
|
||
-- id : region number in QMSS.
|
||
-- region-spec : specifies the number of descriptors in the
|
||
region, specified as
|
||
<"# of descriptors" "descriptor size">.
|
||
-- link-index : start index, i.e. index of the first
|
||
descriptor in the region.
|
||
|
||
Optional properties:
|
||
- dma-coherent : Present if DMA operations are coherent.
|
||
- pdsps : child node describing the PDSP configuration.
|
||
-- firmware : firmware to be loaded on the PDSP.
|
||
-- id : the qmss pdsp that will run the firmware.
|
||
-- reg : Address and size of the register set for the PDSP.
|
||
Register regions should be specified in the following
|
||
order
|
||
- PDSP internal RAM region.
|
||
- PDSP control/status region registers.
|
||
- QMSS interrupt distributor registers.
|
||
- PDSP command interface region.
|
||
|
||
Example:
|
||
|
||
qmss: qmss@2a40000 {
|
||
compatible = "ti,keystone-qmss";
|
||
dma-coherent;
|
||
#address-cells = <1>;
|
||
#size-cells = <1>;
|
||
clocks = <&chipclk13>;
|
||
ranges;
|
||
queue-range = <0 0x4000>;
|
||
linkram0 = <0x100000 0x8000>;
|
||
linkram1 = <0x0 0x10000>;
|
||
|
||
qmgrs {
|
||
#address-cells = <1>;
|
||
#size-cells = <1>;
|
||
ranges;
|
||
qmgr0 {
|
||
managed-queues = <0 0x2000>;
|
||
reg = <0x2a40000 0x20000>,
|
||
<0x2a06000 0x400>,
|
||
<0x2a02000 0x1000>,
|
||
<0x2a03000 0x1000>,
|
||
<0x23a80000 0x20000>,
|
||
<0x2a80000 0x20000>;
|
||
};
|
||
|
||
qmgr1 {
|
||
managed-queues = <0x2000 0x2000>;
|
||
reg = <0x2a60000 0x20000>,
|
||
<0x2a06400 0x400>,
|
||
<0x2a04000 0x1000>,
|
||
<0x2a05000 0x1000>,
|
||
<0x23aa0000 0x20000>,
|
||
<0x2aa0000 0x20000>;
|
||
};
|
||
};
|
||
queue-pools {
|
||
qpend {
|
||
qpend-0 {
|
||
qrange = <658 8>;
|
||
interrupts =<0 40 0xf04 0 41 0xf04 0 42 0xf04
|
||
0 43 0xf04 0 44 0xf04 0 45 0xf04
|
||
0 46 0xf04 0 47 0xf04>;
|
||
};
|
||
qpend-1 {
|
||
qrange = <8704 16>;
|
||
interrupts = <0 48 0xf04 0 49 0xf04 0 50 0xf04
|
||
0 51 0xf04 0 52 0xf04 0 53 0xf04
|
||
0 54 0xf04 0 55 0xf04 0 56 0xf04
|
||
0 57 0xf04 0 58 0xf04 0 59 0xf04
|
||
0 60 0xf04 0 61 0xf04 0 62 0xf04
|
||
0 63 0xf04>;
|
||
qalloc-by-id;
|
||
};
|
||
qpend-2 {
|
||
qrange = <8720 16>;
|
||
interrupts = <0 64 0xf04 0 65 0xf04 0 66 0xf04
|
||
0 59 0xf04 0 68 0xf04 0 69 0xf04
|
||
0 70 0xf04 0 71 0xf04 0 72 0xf04
|
||
0 73 0xf04 0 74 0xf04 0 75 0xf04
|
||
0 76 0xf04 0 77 0xf04 0 78 0xf04
|
||
0 79 0xf04>;
|
||
};
|
||
};
|
||
general-purpose {
|
||
gp-0 {
|
||
qrange = <4000 64>;
|
||
};
|
||
netcp-tx {
|
||
qrange = <640 9>;
|
||
qalloc-by-id;
|
||
};
|
||
};
|
||
accumulator {
|
||
acc-0 {
|
||
qrange = <128 32>;
|
||
accumulator = <0 36 16 2 50>;
|
||
interrupts = <0 215 0xf01>;
|
||
multi-queue;
|
||
qalloc-by-id;
|
||
};
|
||
acc-1 {
|
||
qrange = <160 32>;
|
||
accumulator = <0 37 16 2 50>;
|
||
interrupts = <0 216 0xf01>;
|
||
multi-queue;
|
||
};
|
||
acc-2 {
|
||
qrange = <192 32>;
|
||
accumulator = <0 38 16 2 50>;
|
||
interrupts = <0 217 0xf01>;
|
||
multi-queue;
|
||
};
|
||
acc-3 {
|
||
qrange = <224 32>;
|
||
accumulator = <0 39 16 2 50>;
|
||
interrupts = <0 218 0xf01>;
|
||
multi-queue;
|
||
};
|
||
};
|
||
};
|
||
descriptor-regions {
|
||
#address-cells = <1>;
|
||
#size-cells = <1>;
|
||
ranges;
|
||
region-12 {
|
||
id = <12>;
|
||
region-spec = <8192 128>; /* num_desc desc_size */
|
||
link-index = <0x4000>;
|
||
};
|
||
};
|
||
pdsps {
|
||
#address-cells = <1>;
|
||
#size-cells = <1>;
|
||
ranges;
|
||
pdsp0@0x2a10000 {
|
||
reg = <0x2a10000 0x1000>,
|
||
<0x2a0f000 0x100>,
|
||
<0x2a0c000 0x3c8>,
|
||
<0x2a20000 0x4000>;
|
||
id = <0>;
|
||
};
|
||
};
|
||
}; /* qmss */
|