45 lines
1.5 KiB
Plaintext
45 lines
1.5 KiB
Plaintext
Atmel maXTouch touchscreen/touchpad
|
|
|
|
Required properties:
|
|
- compatible:
|
|
atmel,maxtouch
|
|
|
|
- reg: The I2C address of the device
|
|
|
|
- interrupts: The sink for the touchpad's IRQ output
|
|
See ../interrupt-controller/interrupts.txt
|
|
|
|
Optional properties for main touchpad device:
|
|
|
|
- linux,gpio-keymap: When enabled, the SPT_GPIOPWN_T19 object sends messages
|
|
on GPIO bit changes. An array of up to 8 entries can be provided
|
|
indicating the Linux keycode mapped to each bit of the status byte,
|
|
starting at the LSB. Linux keycodes are defined in
|
|
<dt-bindings/input/input.h>.
|
|
|
|
Note: the numbering of the GPIOs and the bit they start at varies between
|
|
maXTouch devices. You must either refer to the documentation, or
|
|
experiment to determine which bit corresponds to which input. Use
|
|
KEY_RESERVED for unused padding values.
|
|
|
|
- atmel,suspend-mode: Select method used to suspend:
|
|
MXT_SUSPEND_DEEP_SLEEP - use T7 to suspend the device into deep sleep
|
|
MXT_SUSPEND_T9_CTRL - use T9.CTRL to turn off touch processing
|
|
Definitions are in <dt-bindings/input/atmel_mxt_ts.h>.
|
|
|
|
- atmel,reset-gpio: Configure RESET GPIO. Required for regulator support.
|
|
|
|
- atmel,cfg_name: Provide name of configuration file in OBP_RAW format. This
|
|
will be downloaded from the firmware loader on probe to the device.
|
|
|
|
- atmel,input_name: Override name of input device from the default.
|
|
|
|
Example:
|
|
|
|
touch@4b {
|
|
compatible = "atmel,maxtouch";
|
|
reg = <0x4b>;
|
|
interrupt-parent = <&gpio>;
|
|
interrupts = <TEGRA_GPIO(W, 3) IRQ_TYPE_LEVEL_LOW>;
|
|
};
|