60 lines
2.7 KiB
Plaintext
60 lines
2.7 KiB
Plaintext
* Bosch BMP 180/280 pressure sensor
|
|
|
|
nvi_ (NVI = NVidia/Invensense) drivers use the NVidia Sensor (NVS) framework.
|
|
See the nvs.txt documentation for NVS DT capabilities.
|
|
The nvi_bmpX80 pressure sensor driver supports the BMP180 and BMP280 devices
|
|
as stand-alone or behind an Invensense MPU.
|
|
If the part is known and is populated, then it can be specified in the DT:
|
|
Example: bmp280@77.
|
|
By specifying a device this way, the driver will assume this specific device
|
|
is populated during system boot and will not verify its existence. If, however,
|
|
the device is unknown or may not be populated, then the label, ak89xx,
|
|
(e.g. bmpX80@77), must be used. This tells the driver to find which device is
|
|
used. If the device is not found, the driver will unload itself. This also
|
|
requires that regulators be setup correctly for the probe function.
|
|
|
|
Required properties:
|
|
- compatible: Device or generic name.
|
|
Supported names:
|
|
- bmp,bmpX80
|
|
- bmp,bmp180
|
|
- bmp,bmp280
|
|
Note: If the part is known and is populated, then it can be specified:
|
|
Example: compatible = "bmp,bmp280";
|
|
When specifying a device this way, the driver will assume this specific
|
|
device is populated during system boot and will not verify its
|
|
existence. If, however, the device is unknown or may not be populated,
|
|
then the label, bmpX80, (Example: compatible = "bmp,bmpX80";),
|
|
must be used. This tells the driver to find which device is used. If
|
|
the device is not found, the driver will unload itself. This requires
|
|
regulators to be setup correctly for the probe function.
|
|
- reg: i2c address of the device. It should be 0x76 or 0x77.
|
|
|
|
Optional properties:
|
|
- status: set to "ok" or "okay" for normal operation. Set to anything else
|
|
to unload the driver without ever communicating with the device.
|
|
Note: The "anything else" above is typically "disabled".
|
|
Since the driver will unload without communicating with the device, the
|
|
device will be left in its POR state.
|
|
- pressure_disable: Setting this property to <1> will disable the device and
|
|
unload the driver.
|
|
- vdd-supply: regulator supply for the chip
|
|
- vddio-supply: regulator supply for the chip
|
|
Note: These are required if the driver is to control the regulators.
|
|
- nvi_config: This configures the device's I2C connection.
|
|
The string options are: auto
|
|
mpu
|
|
host
|
|
auto = the driver will auto detect the connection.
|
|
mpu = the device is connected to an Invensense auxilary bus.
|
|
host = the device is connected to the host AP.
|
|
If this property is not defined, auto will be used.
|
|
|
|
Example:
|
|
bmpX80@77 {
|
|
compatible = "bmp,bmpX80";
|
|
reg = <0x77>;
|
|
};
|
|
|
|
|