diff --git a/Marlin/Configuration.h b/Marlin/Configuration.h
index a4910300..0c7b4042 100755
--- a/Marlin/Configuration.h
+++ b/Marlin/Configuration.h
@@ -129,7 +129,19 @@
 // Enable the Bluetooth serial interface on AT90USB devices
 //#define BLUETOOTH
 
-// Choose the name from boards.h that matches your setup
+
+/**
+ * Select your version of the Trigorilla (RAMPS1.4) board here.
+ *
+ * BOARD_TRIGORILLA_14     = Default Trigorilla
+ * BOARD_TRIGORILLA_14_11  = Newer Trigorilla v1.1 (first seen late 2018)
+ *
+ * The only major difference is a slight change on the servo pin mapping.
+ * This setting only is relevant if you want to use BLtouch or similar
+ * mods to be used via servo pins.
+ * The new version is to be identified by a "TRIGORILLA1.1" lettering
+ * on the upper left of the PCB silkscreen.
+ */
 #ifndef MOTHERBOARD
   #define MOTHERBOARD BOARD_TRIGORILLA_14
 #endif
@@ -2339,21 +2351,6 @@
 // Allow servo angle to be edited and saved to EEPROM
 //#define EDITABLE_SERVO_ANGLES
 
-/**
- * Select your version of the Trigorilla (RAMPS1.4) board here.
- *
- * 0 = Default Trigorilla
- * 1 = Newer Trigorilla v1.1 (first seen late 2018)
- *
- * The only major difference is a slight change on the servo pin mapping.
- * This setting only is relevant if you want to use BLtouch or similar
- * mods to be used via servo pins.
- * The new version is to be identified by a "TRIGORILLA1.1" lettering
- * on the upper left of the PCB silkscreen.
- */
-#define TRIGORILLA_VERSION 0
-
-// Enable Anycubic TFT
 #define ANYCUBIC_TOUCHSCREEN
 #define ANYCUBIC_FILAMENT_RUNOUT_SENSOR
 //#define ANYCUBIC_TFT_DEBUG