diff --git a/Beginner's-Guide-(English).md b/Beginner's-Guide-(English).md
index 88d98fe..60b2d1b 100644
--- a/Beginner's-Guide-(English).md
+++ b/Beginner's-Guide-(English).md
@@ -84,7 +84,7 @@ The special menu on this display has a peculiarity: Since this display does not
 
 ## 3. Identification of the mainboard
 
-This section is basically only relevant if you have installed a BLTouch or comparable autoleveling sensor and operate it via the servo connection on the main board. If you have not installed a BLTouch or similar, you can skip this entire section and continue with point 4. However, I still recommend opening your own printer once in order to at least tighten the screws for the main supply lines on the motherboard.
+This section is basically only relevant if you have installed a BLTouch or comparable autoleveling sensor and operate it via the servo connection on the main board. If you do not have installed a BLTouch or similar, you can skip this entire section and continue with point 4. However, I still recommend opening your own printer once in order to at least tighten the screws for the main supply lines on the motherboard.
 
 ### Trigorilla 1.0