diff --git a/Beginner's-Guide-(English).md b/Beginner's-Guide-(English).md
index ff4edf8..bac7fc4 100644
--- a/Beginner's-Guide-(English).md
+++ b/Beginner's-Guide-(English).md
@@ -1,5 +1,18 @@
 # Beginner's Guide
 
+## Contents:
+
+* [1. Identification of the printer](#1-identification-of-the-printer)
+* [2. Identification of the display](#2-identification-of-the-display)
+* [3. Identification of the mainboard](#3-identification-of-the-mainboard)
+* [4. Download the correct firmware](#4-download-the-correct-firmware)
+* [5. Install the firmware](#5-install-the-firmware)
+* [6. Load default settings](#6-load-default-settings)
+* [7. Setup slicer (Cura)](#7-setup-slicer-cura)
+* [8. Start and end code](#8-start-and-end-code)
+* [9. Calibrate the extruder](#9-calibrate-the-extruder)
+* [10. PID Tuning](#10-pid-tuning)
+
 ## 1. Identification of the printer
 This firmware works on many Anycubic brand 3D printers, in which a "Trigorilla" mainboard with an Atmega2560 was installed.