Commit Graph

6 Commits

Author SHA1 Message Date
David Ramiro 5432154bf7
Update special menu
• Added auto PID tune of heatbed to the special TFT menu
•Enabled automatic saving on both PID tune commands
• Added preheating and mesh leveling commands to the special TFT menu
• Mentioned changes in readme
2018-11-17 22:02:55 +01:00
David Ramiro 77ceef9625
Tweak e-steps
After getting my extruder to work reliably on a Vref of 1.100V on the TMC2208, I had to adjust my e-steps quite a bit from the original value from Anycubic. Assuming you have a TMC2208 on a similar voltage, this might work well right after flashing, calibrating your e-steps is recommended in any case.
2018-11-17 19:43:48 +01:00
David Ramiro 486e7fbf7d
Fix typos 2018-11-16 20:56:52 +01:00
David Ramiro 003e93652a
Add precompiled hex 2018-11-16 20:15:02 +01:00
David Ramiro 5e56a939e3
Enable heatbed PID mode and add several tweaks
Enable heatbed PID mode and add several tweaks

Enable PIDTEMPBED and add several tweaks

• Enabling heatbed PID tuning
• Tweaking default hotend PID
• Enhancing MMBL grid from 9 points to 25 (3x3 to 5x5 -
 fair warning, leveling might take a few minutes now!)
• Increasing buffer and lowering baudrate to ensure smoother prints via USB
• Removing some redundant stuff to save memory

Thanks to @NetrunnerAT for his recommendations!

Co-Authored-By: NetrunnerAT <netrunnerat@users.noreply.github.com>
2018-11-16 10:50:55 +01:00
David Ramiro 6957194af3
Initial commit
Using TMC2208 in standalone mode, I've inverted the stepper direction to match Anycubics pin layout. M110 memory watcher was removed due to redundancy and - ironically - to save memory.
2018-11-16 10:32:01 +01:00