Finally fix print/pause/resume and M600 filament change.
This commit is contained in:
@@ -2675,7 +2675,7 @@
|
||||
#define FILAMENT_CHANGE_FAST_LOAD_LENGTH 538 // (mm) Load length of filament, from extruder gear to nozzle.
|
||||
// For Bowden, the full length of the tube and nozzle.
|
||||
// For direct drive, the full length of the nozzle.
|
||||
// #define ADVANCED_PAUSE_CONTINUOUS_PURGE // Purge continuously up to the purge length until interrupted.
|
||||
#define ADVANCED_PAUSE_CONTINUOUS_PURGE // Purge continuously up to the purge length until interrupted.
|
||||
#define ADVANCED_PAUSE_PURGE_FEEDRATE 2 // (mm/s) Extrude feedrate (after loading). Should be slower than load feedrate.
|
||||
#define ADVANCED_PAUSE_PURGE_LENGTH 2 // (mm) Length to extrude after loading.
|
||||
// Set to 0 for manual extrusion.
|
||||
@@ -2690,7 +2690,7 @@
|
||||
#define FILAMENT_UNLOAD_PURGE_LENGTH 8 // (mm) An unretract is done, then this length is purged.
|
||||
#define FILAMENT_UNLOAD_PURGE_FEEDRATE 25 // (mm/s) feedrate to purge before unload
|
||||
|
||||
#define PAUSE_PARK_NOZZLE_TIMEOUT 60 // (seconds) Time limit before the nozzle is turned off for safety.
|
||||
#define PAUSE_PARK_NOZZLE_TIMEOUT 300 // (seconds) Time limit before the nozzle is turned off for safety.
|
||||
#define FILAMENT_CHANGE_ALERT_BEEPS 10 // Number of alert beeps to play when a response is needed.
|
||||
#define PAUSE_PARK_NO_STEPPER_TIMEOUT // Enable for XYZ steppers to stay powered on during filament change.
|
||||
// #define FILAMENT_CHANGE_RESUME_ON_INSERT // Automatically continue / load filament when runout sensor is triggered again.
|
||||
|
Reference in New Issue
Block a user