Updated Beginner's Guide (English) (markdown)
@@ -27,7 +27,7 @@ The following are currently supported (as of July 2021):
|
|||||||
- **Chiron** (first generation with Anycubic 1.0 display)
|
- **Chiron** (first generation with Anycubic 1.0 display)
|
||||||
- **Chiron** (second generation with Anycubic 0.0.2 display)
|
- **Chiron** (second generation with Anycubic 0.0.2 display)
|
||||||
|
|
||||||
With every printer it is possible to operate it in its original state, or [replace all stepper motor drivers with TMC22xx](https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S/wiki/Swap-stepper-motor-driver-for-TMC2xxx). In addition, [Autoleveling sensors such as the BLTouch](https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S/wiki/BLTouch-Installation-(english)) retrofit.
|
With every printer it is possible to operate it in its original state, or [replace all stepper motor drivers with TMC22xx](https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S/wiki/Swap-stepper-motor-driver-for-TMC2xxx). In addition, [Autoleveling sensors such as the BLTouch](https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S/wiki/BLTouch-Installation-(english)) retrofit. Since version 1.3.0 it is also possible to additionally integrate a [Wifi module](https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S/wiki/WiFi-Installation-(english)) and thus to control the printer completely via a web interface.
|
||||||
|
|
||||||
If one of these upgrades applies to your own printer, a special firmware version must be installed for each.
|
If one of these upgrades applies to your own printer, a special firmware version must be installed for each.
|
||||||
|
|
||||||
|
Reference in New Issue
Block a user