Updated BLTouch Installation (english) (markdown)
@@ -127,7 +127,7 @@ The installation can be done as usual via Cura. If you're not sure which board y
|
||||
|
||||
Start the Autoleveling via the special menu. After moving to Home, the nozzle lifts up and moves to the first point at X40 Y40 and should then extend the tip of the sensor. If that doesn't happen **IMMEDIATELY** switch off the printer and try the firmware with the **_11** mark. If it still doesn't work, the wiring is incorrect.
|
||||
|
||||
## Configuration
|
||||
## Determination and configuration of the Z offset
|
||||
|
||||
For the next steps we need the printer, a PC and Pronterface
|
||||
|
||||
|
Reference in New Issue
Block a user