Revert frequency changes
Needs more investigation. Suspended for now.
This commit is contained in:
parent
2b4c936c1a
commit
b18052c0c3
|
@ -380,9 +380,9 @@
|
|||
// If you are using a pre-configured hotend then you can use one of the value sets by uncommenting it
|
||||
|
||||
// i3 Mega stock v5 hotend, 40W heater cartridge (3.6Ω @ 22°C)
|
||||
#define DEFAULT_Kp 18.58
|
||||
#define DEFAULT_Ki 1.38
|
||||
#define DEFAULT_Kd 62.40
|
||||
#define DEFAULT_Kp 15.94
|
||||
#define DEFAULT_Ki 1.17
|
||||
#define DEFAULT_Kd 54.19
|
||||
|
||||
// Ultimaker
|
||||
//#define DEFAULT_Kp 22.2
|
||||
|
@ -437,9 +437,9 @@
|
|||
//#define PID_BED_DEBUG // Sends debug data to the serial port.
|
||||
|
||||
//Anycubic i3 Mega Ultrabase (0.9Ω @ 22°C)
|
||||
#define DEFAULT_bedKp 187.45
|
||||
#define DEFAULT_bedKi 35.75
|
||||
#define DEFAULT_bedKd 245.71
|
||||
#define DEFAULT_bedKp 251.78
|
||||
#define DEFAULT_bedKi 49.57
|
||||
#define DEFAULT_bedKd 319.73
|
||||
|
||||
//120V 250W silicone heater into 4mm borosilicate (MendelMax 1.5+)
|
||||
//from pidautotune
|
||||
|
@ -1834,13 +1834,13 @@
|
|||
// Use software PWM to drive the fan, as for the heaters. This uses a very low frequency
|
||||
// which is not as annoying as with the hardware PWM. On the other hand, if this frequency
|
||||
// is too low, you should also increment SOFT_PWM_SCALE.
|
||||
#define FAN_SOFT_PWM
|
||||
//#define FAN_SOFT_PWM
|
||||
|
||||
// Incrementing this by 1 will double the software PWM frequency,
|
||||
// affecting heaters, and the fan if FAN_SOFT_PWM is enabled.
|
||||
// However, control resolution will be halved for each increment;
|
||||
// at zero value, there are 128 effective control positions.
|
||||
#define SOFT_PWM_SCALE 2
|
||||
#define SOFT_PWM_SCALE 0
|
||||
|
||||
// If SOFT_PWM_SCALE is set to a value higher than 0, dithering can
|
||||
// be used to mitigate the associated resolution loss. If enabled,
|
||||
|
|
Loading…
Reference in New Issue